|
Version 10 Released March 10! |
||||||||||||||||
|
New Features |
||||||||||||||||
 |
||||||||||||||||
|
|
|
|||||||||||||||
|
Model Builder This protype model was produced with one click on the Model Builder button. It can now be modified to meet your conditions, and then relaxed. |
Double Mesh Double Mesh can increase MSurf, NSurf or both. Here an application is shown with a deep catenary, which needs a much higher MSurf than NSurf to keep the mesh well behaved over the catenary top. |
|||||||||||||||
|
|
||||||||||||||||
|
Seam Allowance Seam Allowance can overlay the interior panel, add balance marks, stamp the panel and identify the nodes. |
||||||||||||||||
|
Other improvements to MPanel v10:
· Cross Section Can optionally specify a fixed number of points on a cross section.
· Mesh to Polylines Can now reverse warp and weft in a mesh in one operation.
· Panel Production Can now orient the panel by the left edge, with a minimum X coordinate value
· Panel Output Output panels as blocks, splines, etc |
||||||||||||||||
|
Your MPanel Version 10 Delivery |
||||||||||||||||
|
You will have received MPanel version 10 upgrade pack automatically if:
(a) You have purchased MPanel within the last 12 months or (b) You have purchased an annual Technical Support Contract entitling you to free upgrades and support.
If you are an MPanel user who hasn’t yet received your copy of MPanel version 10, please contact us. |
||||||||||||||||
| In
the US & Americas contact: Timothy Akes CAD Effects, LLC 10805 Sunset Office Drive, Ste 300 St. Louis, Missouri 63127 USA (314) 631-6300 voice (314) 754-9388 fax |
In
Australia contact: Alan Stewart Structureflex 280 Bay Road Cheltenham, 3192 Victoria, AU (03)9581 6150 voice (03) 9581 6177 fax |
In the UK, Europe, & Asia contact: Andrew Askwith Meliar Design Lower Cwm Barns Llanafan Fawr Builth Wells, Powys, Wales, UK LD2 3SG +44 (0)1597 860291 andrew@meliar.com |
||||||||||||||
